Skip to main content

Encoders

Existing support for encoders in ZMK is focused around the five pin EC11 rotary encoder with push button design used in the majority of current keyboard and macropad designs.

Enabling EC11 Encoders​

To enable encoders for boards that have existing encoder support, uncomment the CONFIG_EC11=y and CONFIG_EC11_TRIGGER_GLOBAL_THREAD=y lines in your board's .conf file in your zmk-config/config folder. Save and push your changes, then download and flash the new firmware.

Customizing EC11 Encoder Behavior​

Encoder behavior in ZMK is configured in two different locations as the push button and rotation behaviors are handled in two separate ways.

Push Button​

Keyboards and macropads with encoder support will typically take the two EC11 pins responsible for the push button and include them as part of the matrix for the keys. To configure what is sent by the push button, find the encoder's position in the keyboard matrix and assign it a behavior the same as you would any other key.

Rotation​

Rotation is handled separately as a type of sensor. The behavior for this is set in sensor-bindings. See Sensor Rotation for customizing this behavior.

sensor-bindings = <BINDING [CW_KEY] [CCW_KEY]>;
  • BINDING is either a user-defined behavior, or &inc_dec_kp for key presses (see Key Press for details on available keycodes).
  • CW_KEY is the keycode activated by a clockwise turn.
  • CCW_KEY is the keycode activated by a counter-clockwise turn.

Additional encoders can be configured by adding more bindings immediately after the first.

As an example, a complete sensor-bindings for a Kyria with two encoders could look like:

sensor-bindings = <&inc_dec_kp C_VOL_UP C_VOL_DN &inc_dec_kp PG_UP PG_DN>;

Here, the left encoder is configured to control volume up and down while the right encoder sends either Page Up or Page Down.

Adding Encoder Support​

See the Hardware Integration page for encoders for instructions on adding them to your keyboard.